Secure your room and facility with our bullet proof woven fiberglass panels. Our panels come in various sizes and can be used in your security wall, panic room, safe room, or anywhere a ballistic protective barrier is desired or replacement for your wall board.

Covenant Security Equipment offers UL 752 Listed Bullet and Blast Protection Composite Panels. This material is manufactured using a woven roving ballistic grade cloth that is manufactured in-house. The cloth is mechanically injected with resin and placed in a hydraulic hot press, then pressed into flat rigid sheets. By using an anti-ballistic grade fiber in our cloth, we can maximize the ballistic performances by consistently achieving a uniform resin to fiber ratio. This allows the proper ply de-lamination to capture projectiles.

Bullet and Blast Protection Panels are approved by the U.S. Marshal Service, the General Services Administration, and comply with NIJ standards. Please refer to our Ballistics Chart for detailed information. Our composite panels are also compliant with ASTM E119A for one hour fire wall construction.

Make Up
Multiple layers of woven roving ballistic grade fiberglass cloth woven in house impregnated with a thermoset polyester resin and compressed into flat rigid sheets designed to capture projectiles. 

Preformance Level
Underwriters Laboratory UL 752 11th Edition Standard for Bullet Resisting Equipment. One hour fire rated to ASTM E119-00a Building Construction and Materials. 

Manufacture Warranty
Materials and workmanship shall be warranted against defects for a period of two (2) years from the date of receipt at the project site. 

Any butt joints or seams create a ballistic weakness at the seam. To insure ballistic integrity, we recommend that you incorporate 4" overlap strips (battens). These strips insure a 2" ballistic overlap on each side of the seam. Conformity to curved surfaces can be handled by placing 12" to 18" vertical strips following the inside curvature of the surface to be protected. The same 4" overlap strips should be employed at each joint.

The panels easily accepts a wood or plastic veneer using contact cement. It may also be upholstered or painted. To paint we recommend "roughing up" the surface with sandpaper.  Panels can be used as a drywall supply alternative. 

Curved Desk or Wall
Bending panels around a curved desk or wall is possiable using Level 1 panels only.  A level 3 rating can be achieved by cutting the panels to size and segmenting them or by overlapping the panels to cover the seams.  Using stacked Level 1 panels at 1/4” thick will equal the 1/2” Level 3 desired protection.  

Cutting the Panels
Use our RemGrit circular saw blades.

More information visit our blog
Installation for Bullet Resistant Panels